Excilor Nail Fungus Ultra Colour Nude 30ml
Excilor Nail Fungus Ultra Colour Nude 30ml
Fungal nail infections are difficult to reach and to treat as the infection grows on both the inside and outside of the nail.
Excilor was specifically developed to treat fungal nail infections and is based on three principles:
- Effective mode of action: Excilor controls the nail's microenvironment and changes the pH's levels making it hostile for fungal growth.
- Optimal, rapid and complete nail penetration: Excilor has Transactive Technology, a unique and superior nail penetration technology, that enables to penetrate reach deep in the nail so it is treated from the inside out.
- Convenience: Easy and quick to apply, no need to file the nail and dries within seconds. It usually takes a few months before an affected nail looks completely healthy again as the damaged nail needs time to grow out. On average, a toenail grows 1.5 mm in one month.
- Optimal Penetration
- One minute a day
- No filing required
- Results will be visible when the nail begins to grow back
You can buy Excilor Nail Fungus Ultra Colour Nude 30ml online in Australia from Chemist Direct
- Excilor FORTE Color must be applied once a day preferably after showering. Before application clean the nail and remove any old layers of nail varnish. Shake the bottle well before application.
- Next, apply a uniform coating of Excilor FORTE Color on the whole nail surface to treat. Gently remove any excess of product from the borders of surrounding skin. The bottle may contain cloths of dried film residue. Wipe off any clots of dried film from the brush. This is normal and caused by drying from air contact. It has no influence on product performance or quality.
- Allow the nail to dry. This takes between 3 to 5 minutes. A slightly glossy film is formed. For optimal effect it is advisable to wait for up to 5 minutes before putting on socks and/or shoes. After application, a tingling sensation under the nail is normal and indicates that the
product is penetrating the nail. Excilor FORTE Color should not be used on healthy nails. A normal nail lacquer with the same colour is available. The formed coating is water-resistant and withstands normal wear and friction. The coating may chip off at the edges of the nail but this does not affect product efficacy. - After 24h, remove the film. You can do this by peeling off the coating at the edge or side of the nail. Gently roll off until the complete coating is released from the nail. You may find thiseasier by using warm water. Apply new product, as instructed above. Wash your hands well after each removal and subsequent application. For best results, treat the complete nail for a minimum of three months and continue the course of treatment until the nail has recovered completely.
- Make sure that the bottle is fully closed after each treatment to prevent evaporation. At the boarder of the glass film formation may
occur
Butyl Acetate, Ethyl Acetate, Nitrocellulose,
Adipic Acid/Neopentyl Glycol/Trimellitic Anhydride Copolymer,
Acetyl Tributyl Citrate, Isopropyl Alcohol, Acrylates Copolymer,
Stearalkonium Bentonite, n-Butyl Alcohol, Styrene/Acrylates
Copolymer, CI 77891, Silica, Benzophenone-1, Trimethylpentanediyl
Dibenzoate, Polyvinyl Butyral, CI 19140, CI 77491, Diacetone Alcohol.
For external use only. Apply on nail only, avoid contact with the surrounding skin. Avoid all contact with eyes and mucous membranes. If the product comes into contact with eyes or mucous membranes, rinse thoroughly with water. No clinical data are available on use of the product on children or pregnant women.
